Table of Contents
Driver Monitoring System Features #
| Functions | Descriptions | Beep Alert |
| Power On | When power is turned on, the DMS booting up. | X |
| Detected | Detects the face within the range of 15 degree to top, bottom, left and right based on the center of the lens. | DMS On |
| Undetected | When driver is out of detection range for 60 seconds, it will be detected as No driver. | X |
| Drowsiness | When driver’s eyes close for more than 1.5 second, it will be detected as drowsy. | Beep + Drowsy |
|
Distraction |
When driver turns head to one side (left or right) more than about 50 degrees for 3 seconds,
it will be detected as distracted. |
Beep + Distraction |
| Seatbelt | When driver does not wear a Seatbelt for 30 seconds , DMS alert driver to wear the seatbelt. | Beep + Fasten your seatbelt |
| Power Off | When power is turned off, the DMS is turned off. | X |
Note
- Please note that if a driver is wearing a mask, eye patch, sunglasses, or a hat, the DMS may not operate as intended.
- Strong sunlight may prevent the seatbelt detection.
- Drive position can be set up in the settings. (Left Hand Drive / Right Hand Drive)
- DMS Calibration is require for Distraction.
- Among the functions, Distraction/Drowsiness is not available if GPS is under threshold settings. (Threshold: 0km/h~80km/h)
- Algorithm may change in order to improve accuracy.
