The following diagrams explain each part of the BlackVue dashcam.
Front camera
A) Lock button
B) Mounting bracket
C) Front security LED:
: Lights on during (i) normal mode, (ii) an event is being recorded (impact detected), (iii) manual recording has started, or (iv) motion is detected in parking mode.
: Blinks slowly during parking mode motion detection standby.
D) Camera lens
A) GPS LED:
: Lights blue when GPS is on.
: Blinks blue quickly when GPS is turning off.
B) Speaker
C) Recording LED:
: Lights orange in normal mode.
: Lights red when (i) an event is being recorded (impact detected), or (ii) manual recording has started.
: Lights green in parking mode when motion is detected.
D) Bluetooth/ Wi-Fi/ LTE LED:
: Lights yellow when LTE is connected.
: Lights white when Wi-Fi is connected.
: Blinks Yellow slowly when Bluetooth is paired.
: Blinks Yellow quickly when Bluetooth is in pairing mode.
A) Touch Sensor:
Press the sensor to trigger a manual recording.
* Touch sensor can be turned on/off in the firmware settings.
A) Micro USB port
B) DC in (power connector)
C) microSD card slot
D) Format button:
– Press and hold for 5 seconds, and after a beep, release the button. Then, press again and hold for 5 seconds and release the button after a beep to format the microSD card.
E) Cover
F) Rear camera connection port
Removing and inserting the front camera
A) Connectivity details label: Default Wi-Fi SSID / Default Wi-Fi password / Cloud code / QR code
B) Serial number label
• To remove the dashcam from its bracket, press the LOCK button and pull the dashcam out of the mounting bracket.
• To insert the dashcam into its bracket, push the dashcam into the mounting bracket until it “clicks” in.
Interior/DMS camera
A) Mounting bracket
B) Indicator LED
: Light Blue in Calibration
: Light Green in Normal mode
: When DMS event detecte, Light Red is turned on
C) IR LED (Inside)
D) Camera lens (Inside)
A) Turn on/off audio beep
B) Push botton
C) Front camera connection port
D) DC in
