🚘 BlackVue Tamper Proof (TP-E) Installation Guide
📌 Step-by-Step Installation
Step 1. Unplug cables and remove the dashcam from the windshield
If the dashcam is installed on the windshield, unplug all cables and remove the dashcam with mount.
Step 2. Remove the mount from the front camera
Press the LOCK button and pull the dashcam out of its mounting bracket.
Step 3. Slide into the dashcam with left piece
Slide the Tamper proof bracket (Left piece) into the dashcam until it “Clicks”.
Step 4. Plug in all dashcam cables and align with right piece
Plug in all dashcam cables. Align the right piece with the Tamper proof bracket (Left piece).
The right piece is printed with the BlackVue logo.
Step 5. Combine all the pieces together and tighten via screws
Push the two pieces together and use the Allen wrench to tighten the two screws.
Step 6. Install the dashcam on the windshield and tighten via screw
Install the dashcam on the windshield at a suitable angle and tighten the screw into the Tamper proof bracket (Left piece).
