The following diagrams explain each part of the BlackVue dashcam.
Front camera #
A) Lock button
B) Mounting bracket
C) Front security LED:
: Lights on during (i) normal mode, (ii) an event is being recorded (impact detected), (iii) manual recording has started, or (iv) motion is detected in parking mode.
: Blinks slowly during parking mode motion detection standby.
D) Camera lens
A) GPS LED:
: Lights blue when GPS is on.
: Blinks blue quickly when GPS is turning off.
B) Speaker
C) Recording LED:
: Lights orange in normal mode.
: Lights red when (i) an event is being recorded (impact detected), or (ii) manual recording has started.
: Lights green in parking mode when motion is detected.
D) Bluetooth/ Wi-Fi/ LTE LED:
: Lights yellow when LTE is connected.
: Lights white when Wi-Fi is connected.
: Blinks Yellow slowly when Bluetooth is paired.
: Blinks Yellow quickly when Bluetooth is in pairing mode.
A) Proximity Sensor LED:
: Lights when proximity sensor is triggered.
B) Proximity Sensor:
Touch or wave a finger within 20mm of the sensor to trigger a customizable function.
• Available options:
– Turn on/off audio recording (default)
– Manual recording trigger
– Off
A) Micro USB port
B) DC in (power connector)
C) microSD card slot
D) Wi-Fi button: Press once to turn on/off Wi-Fi.
E) Cover
Removing and inserting the front camera #
A) Connectivity details label: Default Wi-Fi SSID / Default Wi-Fi password / Cloud code / QR code
B) Serial number label
• To remove the dashcam from its bracket, press the LOCK button and pull the dashcam out of the mounting bracket.
• To insert the dashcam into its bracket, push the dashcam into the mounting bracket until it “clicks” in.
Rear camera (DR900X-2CH Plus only) #
A) Mounting bracket
B) Camera lens
A) V out (Front camera connection port)
B) Rear security LED
: Stays on in all recordings modes but can be turned off from firmware settings.
Removing and inserting the rear camera (DR900X-2CH Plus only) #
• To remove the rear camera from its bracket, hold the mounting bracket and pull the rear camera out.
• To insert the rear camera into its bracket, push the rear camera into the mounting bracket until it “clicks” in.
