The following diagrams explain each part of the BlackVue dashcam.
Front camera #
A) Lock button
B) Mounting bracket
C) Front security LED:
: Lights on during (i) normal mode, (ii) an event is being recorded (impact detected), (iii) manual recording has started, or (iv) motion is detected in parking mode.
: Blinks slowly during parking mode motion detection standby.
D) Camera lens
A) Bluetooth/ Wi-Fi/ LTE LED:
: Lights yellow when LTE is connected.
: Lights white when Wi-Fi is connected.
: Blinks Yellow slowly when Bluetooth is paired.
: Blinks Yellow quickly when Bluetooth is in pairing mode.
B) Recording LED:
: Lights orange in normal mode.
: Lights red when (i) an event is being recorded (impact detected), or (ii) manual recording has started.
: Lights green in parking mode when motion is detected.
C) GPS LED
: Lights blue when GPS is on.
: Blinks blue quickly when GPS is turning off.
A) Touch Sensor
Press the sensor to trigger a manual recording.
*Touch sensor can be turned on/off in the firmware settings.
A) Rear camera connection port
B) MicroSD card slot
C) DC in (power connector)
Removing and inserting the front camera #
A) Connectivity details label: Default Wi-Fi SSID / Default Wi-Fi password / Cloud code / Serial number / QR code / IMEI number
B) SIM card slot
• To remove the dashcam from its bracket, press the LOCK button and pull the dashcam out of the mounting bracket.
• To insert the dashcam into its bracket, push the dashcam into the mounting bracket until it “clicks” in.
Interior/rear camera #
A) Mounting bracket
B) Camera lens
C) Illumination sensor
D) IR LED
A) V out (Front camera connection port)
B) Security LED
: Stays on in all recordings modes but can be turned off from firmware settings.
Removing and inserting the interior/rear camera #
• To remove the rear camera from its bracket, hold the mounting bracket and pull the rear camera out.
• To insert the rear camera into its bracket, push the rear camera into the mounting bracket until it “clicks” in.